Shure DP11EQ Manuel d'utilisateur télécharger pdf (Page 8)

English –

DP11EQ SOFTWARE

Introduction

This section describes the Windows-based computer interface software which allows you to

control the Shure DP11EQ . The software controls a dynamics processor which can operate as a

gate, expander, leveler, compressor, limiter, and no overshoot peak limiter. There are parametric

equalizers placed before and after the dynamics processor. In addition, there is a digital delay which

can add up to 1.3 seconds of delay from input to output.

Minimum Computer Requirements

The following are the minimum requirements to run the Shure DP11EQ software.

S One 486DX 50 MHz IBM*-compatible computer (math coprocessor required)

S 2 MB hard drive space

S 4 MB RAM

S Windows version 3.1x, or greater

S 1 available RS-232 serial (COM) port

S One RS-232 cable to connect the COM port of the computer to the DB-9

connector of the DP11EQ

Connecting the DP11EQ to a Computer via the RS-232 (COM) Port

Before connecting the DP11EQ to the computer, determine whether the computer’s RS-232

(COM) port is 9-pin or 25-pin. Use the proper cable (purchased separately). For RS-232 cable

diagrams, see

Appendix C. Cables and Connectors.

TO DP11EQ

RS-232 CABLE

(9-PIN MALE)

TO COMPUTER

RS-232 CONNECTOR

1. Connect the 9-pin plug (male) of the cable to the RS-232 port of the DP11EQ .

2. Connect the other end of the cable to the RS-232 port of the computer.

Software Installation

1. Insert the supplied 3.5-in floppy disk into the disk drive of your computer.

For computers running Windows 95 or Windows NT,

click on the

Start

button , then

select

Run...

For computers running Windows 3.1,

click on the

File

heading of the main menu of the

Program Manager, then click on

Run...

3. In the

Run

window, type “a:\setup”, where “a” is the drive containing the disk.

4. Shure Setup will suggest a destination on your hard disk for the DP11EQ files. Shure

Setup will check the computer hardware to ensure that a coprocessor is present. Setup

will also prompt you for your name and organizational information.

NOTE: Remember to register your software by filling out and mailing the

enclosed registration card, or online via the Shure World Wide Web site

(“http://www.shure.com”). This will ensure that you receive information about

software updates with additional features as they become available.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Shure DP11EQ Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical Shure DP11EQ