Shure DP11EQ Manuel d'utilisateur télécharger pdf (Page 4)

English –

DP11EQ HARDWARE

Overview

Front Panel

DATA

ÊËÌ Í ÎÏ

Ê BYPASS Button and LED. Press this button to

suspend all signal processing from the audio path.

When the LED illuminates, the dynamics

processor, delay, and the equalizers are

bypassed.

Ë SIGNAL LED. Illuminates when input signal is

present. Intensity varies with input signal level.

Ì CLIP LED. Illuminates when the input signal is

within 6 dB of clipping.

Í Dynamic Gain Meters. The 7 red LEDs on the left

indicate the reduction in dynamic range, while the

three yellow LEDs on the right indicate dynamic

boost.

Î DATA LED. This LED indicates that the computer

is communicating with the unit via the RS-232 port.

Ï POWER LED. LED illuminates when unit is

powered on.

Back Panel

ÎÏÌËÊÍ

Power Connector with Integral Fuse. Connects

to AC power. The fuse is located in the drawer

below the connector.

Ë 9-Pin RS-232 Port. Connects the unit to a

computer. For use with DP11EQ software and for

DSP firmware upgrades.

Ì Shure Link Interface. Allows linking of up to 16

Shure Link compatible devices which may be

accessed by a single computer.

Í DIP Switches. See

DIP Switches

Î Output Connector—

-Inch & XLR. Active,

cross-coupled, balanced outputs can be used with

balanced or unbalanced inputs. Can be switched

between +4 dBu/–10 dBV line-level operation by

DIP switch.

-Inch and XLR are driven

independently and either can be balanced or

unbalanced without affecting the other.

Ï Input Connector—Combined XLR and

-Inch. Active balanced input can be used with

balanced or unbalanced outputs. Can be switched

between +4 dBu/–10 dBV line-level operation by

DIP switch.

1 2 3 4 5 6 7 8 9 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Shure DP11EQ Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement musical Shure DP11EQ