Shure DFR11EQ Guide de l'utilisateur télécharger pdf (Page 11)

OMPUTER INTERFACE

Overview

This section describes the Windows based computer interface software which allows

you

to utilize the full features of the Shure DFR1

1EQ.

By connecting the DFR1

1EQ to your

computer, you can access additional control features to customize the operating

characteristics of the feedback filters. The computer interface also allows access to the

built-in digital, 30-band,

-octave, constant-Q, graphic equalizer. The resulting

equalization curves can be displayed in the frequency response graph for an accurate

display

of either the feedback filter response, EQ response, or both combined.

Minimum Computer Requirements

The

following are the minimum requirements to run the Shure DFR1

1EQ software.



One 486DX 33MHz IBM*-compatible computer (math coprocessor required)



2 MB hard drive space



4 MB RAM



Windows version 3.1x, or greater



1 available RS-232 serial (COM) port

 One

RS-232 cable to connect the COM port of the computer to the DB-9 connector of

the

DFR1

1EQ

Connecting the DFR11EQ to a Computer via the RS-232 (COM) Port

Before connecting the DFR11EQ to the computer, determine whether the computer’s

RS-232 (COM) port is 9-pin or 25-pin. Use the proper cable (purchased separately). For

RS-232

cable diagrams, see

Appendix C. Cables and Connectors.

TO DFR11EQ

RS-232 CONNECTOR

(9-PIN MALE)

TO COMPUTER

RS-232 CONNECTOR

1. Connect

the 9-pin plug (male) of the cable to the RS-232 port of the DFR1

1EQ.

Connect the other end of the cable to the RS-232 port of the computer

Main Menu

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Shure DFR11EQ Guide de l'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Égalisateurs audio Shure DFR11EQ